Gigabyte 7VM400M-RZ user manual Fpanel 2 x 10 pins Connector, Faudio Front Audio Connector

7) F_PANEL (2 x 10 pins Connector)

Please connect the power LED, PC speaker, reset switch and power switch etc. of your chassis front panel to the F_PANEL connector according to the pin assignment below.

Message LED/Power/	Power
Sleep LED	Switch	Speaker Connector

	MSG+ MSG- PW+ PW-		SPEAK+	SPEAK-
	1	1	1	20
	2
	1			19
	1	1
	HD+ HD- RES- RES+ NC
	IDE Hard Disk	Reset Switch
	Active LED
HD (IDE Hard Disk Active LED)	Pin 1: LED anode(+)
	Pin 2: LED cathode(-)
SPK (Speaker Connector)	Pin 1: VCC(+)
	Pin 2- Pin 3: NC
	Pin 4: Data(-)
RES (Reset Switch)	Open: Normal Operation
	Close: Reset Hardware System
PW (Power Switch)	Open: Normal Operation
	Close: Power On/Off
MSG (Message LED/ Power/ Sleep LED)	Pin 1: LED anode(+)
	Pin 2: LED cathode(-)
NC	NC

8) F_AUDIO (Front Audio Connector)

If you want to use Front Audio connector, you must remove 5-6, 9-10 Jumper.

In order to utilize the front audio header, your chassis must have front audio connector. Also please make sure the pin assigment on the cable is the same as the pin assigment on the MB header. To find out if the chassis you are buying support front audio connector, please contact your dealer. Please note, you can have the alternative of using front audio connector or of using rear audio connector to play sound.

		Pin No.	Definition
1	2	1	MIC
		2	GND
		3	MIC_BIAS
		4	Power
9	10	5	Front Audio (R)
		6	Rear Audio (R)
		7	Reserved
		8	No Pin
		9	Front Audio (L)
		10	Rear Audio (L)

English

- 15 - Hardware Installation Process