Gigabyte 7VM400M-RZ user manual Clrcmos Clear Cmos, BAT Battery

Page 18

English

15) CLR_CMOS (Clear CMOS)

You may clear the CMOS data to its default values by this jumper. To clear CMOS, temporarily short 1-2 pin. Default doesn't include the "Shunter" to prevent from improper use this jumper.

Close: Clear CMOS

1

Open: Normal

1

16) BAT (Battery)

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer's instructions.

If you want to erase CMOS...

1.Turn OFF the computer and unplug the power cord.

2.Remove the battery, wait for 30 seconds.

3.Re-install the battery.

4.Plug the power cord and turn ON the computer.

7VM400M-RZ Motherboard

- 18 -

Image 18
Contents 7VM400M-RZ Motherboard 7VM400M-RZ Installing the motherboard to the chassis Preparing Your ComputerTable of Contents Features Summary Introduction7VM400M-RZ Motherboard Layout 7VM400M-RZBlock Diagram EnglishHardware Installation Process Set System Jumper JP1Step Install the Central Processing Unit CPU CPU InstallationInstall Memory Modules Install AGP Card Install I/O Peripherals CablesLine Out jack ` MIC In jackATX ATX Power Cpufan CPU Fan ConnectorSysfan System Fan Connector FDD Floppy Connector IDE1 / IDE2 IDE1 / IDE2 ConnectorFpanel 2 x 10 pins Connector Faudio Front Audio ConnectorSurcen Surround Center Connector Spdif Spdif Out ConnectorCdin CD In Connector Comb COM B Connector Game Game ConnectorFUSB1 / FUSB2 Front USB Connector BAT Battery Clrcmos Clear CmosMain Menu For example Bios Ver. F5 Status Page Setup Menu / Option Page Setup MenuMain Menu PnP/PCI Configuration Advanced Bios FeaturesPower Management Setup Load Fail-Safe DefaultsTime Standard Cmos FeaturesDate IDE Primary Master, Slave / IDE Secondary Master, SlaveHalt on Floppy 3 Mode Support for Japan AreaDrive a / Drive B MemoryAdvanced Bios Features First / Second / Third Boot DevicePassword Check Integrated Peripherals USB Mouse Support On-Chip LAN Boot ROMParallel Port Mode Onboard Serial PortPower Management Setup PnP/PCI Configurations PC Health Status Frequency/Voltage Control Load Fail-Safe Defaults Load Optimized DefaultsDimm OverVoltage Control Set Supervisor/User Password ConfigurationsEnter PasswordSave & Exit Setup Exit Without SavingInstall Drivers Install Chipset DriversPictures below are shown in Windows XP Item Description Contact Us Taiwan HeadquartersChina Shanghai