Gigabyte 7VM400M-RZ Drive a / Drive B, Floppy 3 Mode Support for Japan Area, Halt on, Memory

Page 22
No floppy drive installed
5.25 inch PC-type standard drive; 360K byte capacity. 5.25 inch AT-typehigh-density drive; 1.2M byte capacity (3.5 inch when 3 Mode is Enabled).
3.5 inch double-sided drive; 720K byte capacity
3.5 inch double-sided drive; 1.44M byte capacity.
3.5 inch double-sided drive; 2.88M byte capacity.

English

Drive A / Drive B

The category identifies the types of floppy disk drive A or drive B that has been installed in the computer.

None

360K, 5.25" 1.2M, 5.25"

720K, 3.5"

1.44M, 3.5" 2.88M, 3.5"

Floppy 3 Mode Support (for Japan Area)

Disabled

Normal Floppy Drive. (Default value)

Drive A

Drive A is 3

mode Floppy Drive.

Drive B

Drive B is 3

mode Floppy Drive.

Both

Drive A & B are 3 mode Floppy Drives.

Halt on

The category determines whether the computer will stop if an error is detected during power up.

No Errors

The system boot will not stop for any error that may be detected and you

 

will be prompted.

All Errors

Whenever the BIOS detects a non-fatal error the system will be stopped.

All, But Keyboard

The system boot will not stop for a keyboard error; it will stop for all other

 

errors. (Default value)

All, But Diskette

The system boot will not stop for a disk error; it will stop for all other errors.

All, But Disk/Key

The system boot will not stop for a keyboard or disk error; it will stop for all

 

other errors.

Memory

The category is display-only which is determined by POST (Power On Self Test) of the BIOS.

Base Memory

The POST of the BIOS will determine the amount of base (or conventional) memory installed in the system.

The value of the base memory is typically 512K for systems with 512K memory installed on the motherboard, or 640K for systems with 640K or more memory installed on the motherboard.

Extended Memory

The BIOS determines how much extended memory is present during the POST.

This is the amount of memory located above 1 MB in the CPU's memory address map.

Total Memory

This item displays the memory size that used.

7VM400M-RZ Motherboard

- 22 -

Image 22
Contents 7VM400M-RZ Motherboard 7VM400M-RZ Installing the motherboard to the chassis Preparing Your ComputerTable of Contents Features Summary Introduction7VM400M-RZ Motherboard Layout 7VM400M-RZBlock Diagram EnglishSet System Jumper JP1 Hardware Installation ProcessStep Install the Central Processing Unit CPU CPU InstallationInstall Memory Modules Install AGP Card Install I/O Peripherals CablesLine Out jack ` MIC In jackCpufan CPU Fan Connector ATX ATX PowerSysfan System Fan Connector FDD Floppy Connector IDE1 / IDE2 IDE1 / IDE2 ConnectorFpanel 2 x 10 pins Connector Faudio Front Audio ConnectorSpdif Spdif Out Connector Surcen Surround Center ConnectorCdin CD In Connector Game Game Connector Comb COM B ConnectorFUSB1 / FUSB2 Front USB Connector BAT Battery Clrcmos Clear CmosStatus Page Setup Menu / Option Page Setup Menu Main Menu For example Bios Ver. F5Main Menu PnP/PCI Configuration Advanced Bios FeaturesPower Management Setup Load Fail-Safe DefaultsTime Standard Cmos FeaturesDate IDE Primary Master, Slave / IDE Secondary Master, SlaveHalt on Floppy 3 Mode Support for Japan AreaDrive a / Drive B MemoryFirst / Second / Third Boot Device Advanced Bios FeaturesPassword Check Integrated Peripherals USB Mouse Support On-Chip LAN Boot ROMParallel Port Mode Onboard Serial PortPower Management Setup PnP/PCI Configurations PC Health Status Frequency/Voltage Control Load Optimized Defaults Load Fail-Safe DefaultsDimm OverVoltage Control Set Supervisor/User Password ConfigurationsEnter PasswordSave & Exit Setup Exit Without SavingInstall Chipset Drivers Install DriversPictures below are shown in Windows XP Item Description Contact Us Taiwan HeadquartersChina Shanghai