Gigabyte GA-K8N51GMF-9-RH user manual Yes

Step 5:

Next, select the hard drives which you wish to be included in the disk array. The Free Disks section displays the information about the currently installed SATA hard drives. Press the TAB key to move to the Free Disks section. Select the target hard drives using the UP or DOWN ARROW key and use the RIGHT ARROW key to add the hard drives to the Array Disks section (Figure 8).

MediaShield RAID Utility July 27 2005

- Define a New Array -

RAID Mode: Striping				Striping Block: Optimal
Free Disks				Array Disks
Loc	Disk Model	Capacity		Loc	Disk Model	Capacity
				2.0.M	ST3120026AS	111.79GB
		[	] Add	2.1.M	ST3120026AS	111.79GB
		[	] Del
	[ESC] Quit	[F6] Back [F7] Finish	[TAB] Navigate		[ ] Select	[ENTER] Popup

Figure 8

Step 6:

Press F7 after selecting the target hard disks. A message which says "Clear disk data?" will appear (Figure 9). If you are sure to clear the data in the selected hard drives, press Y. (If the hard drives contain previously created RAID array, you need to press Y to clear the data from the hard drives.)

MediaShield RAID Utility July 27 2005

- Define a New Array -

RAID Mode: Striping					Striping Block: Optimal
Free Disks			Clear disk dataArray? Disks
Loc	Disk Model	Capacity			Loc	Disk Model		Capacity
			Clear disk data ?				ST3120026AS	111.79GB
			[Y] YES		1.0.M
					[N] NO		ST3120026AS	111.79GB
			[	] Add	1.1.M
			[Y] YES		[N] NO
			[	] Del
	[ESC] Quit	[F6] Back [F7] Finish		[TAB] Navigate		[ ] Select		[ENTER] Popup

Figure 9

English

- 69 - Appendix