Tuner
< Make sure the antennas have been connected (see page 4 and 5).
1 Select TUNER by pressing the FM/AM button.
Each time the FM/AM button is pressed, the mode is changed as follows:
FM ST 
FM MONO 
AM
FM ST:
FM stereo broadcasts are received in stereo and the “ST” indicator lights in the display.
<If the sound is distorted and the “ST” indicator flashes, the signal is not strong enough for good stereo reception. In this case, change to MONO mode.
FM MONO:
To compensate for weak FM stereo reception, select this mode. Reception will now be forced monaural, reducing unwanted noise.
AM:
AM broadcasts are received.
2Select the station you want to listen to (auto selection).
Hold down the TUNING button (‡ or °) for more than 0.5 seconds.
When a station is tuned in, the tuning process will stop automatically.
If you want to stop the tuning process, press the TUNING button (‡ or °).
Selecting stations which cannot be tuned automatically (manual selection)
When the TUNING button (‡ or °) is pressed momentarily (0.5 second or less), the frequency changes by a fixed step.
Press the TUNING button (‡ or °) repeatedly until the station you want to listen to is found.
<“TUNED” is displayed when a broadcast is correctly tuned in.
24