Settings (Speaker Setup)
After you have installed this receiver and connected all the components, you should adjust the speaker settings for the optimum sound acoustics according to your environment and speaker layout.
When you change speakers, speaker positions, or the layout of your listening environment, you should adjust the speaker settings, too.
Speaker Configuration (CONFIG)
You should select the size of the speakers that are connected. Press the SELECT button (5 or b) to select “CONFIG”, then press the ENTER button. Press the SELECT button (5 or b) to select each speaker, then press the SELECT button (g or t) to set the size.
Depending on your speaker type, you should select one of the following speaker types:
L (Large): Select this when connecting speakers that can fully reproduce sounds below crossover frequency.
S (Small): Select this when connecting speakers that cannot fully reproduce sounds below crossover frequency. When this is selected, sounds below crossover frequency are sent to the subwoofer or speakers which are set to “L (Large)” (when not using a subwoofer).
N (None): Select this when no speakers are connected. When this is selected, sounds are sent to the speakers which are not set to “N (None)”.
Y (Yes)/N (No):
Select “Y (Yes)” when a subwoofer is connected. Select “N (No)” when a subwoofer is not used.
<When speakers are set to “S (Small)”, you should set their crossover frequency correctly according to their frequency characteristics.
<When
<When the “FRONT” is set to “S (Small)”, “CENTER” and “SURR” cannot be set to “L (Large)”.
About speaker size
<Select “L (Large)” or “S (Small)” not according to the actual size of the speaker but according to the speaker’s capacity for playing low frequency (bass sound below frequency set on the
<If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so as not to damage the speakers) to determine the proper setting.
Speaker distance (DISTANCE)
You should enter the distance between the listening position and each speaker to set the delay time automatically for optimum surround playback.
When enjoying
Press the SELECT button (5 or b) to select “DISTANCE”, then press the ENTER button. Press the SELECT button (5 or b) to select the desired item, then press the SELECT button (g or t) to set the selected item as desired.
<You cannot select the subwoofer and the speakers set to “N (None or No)”.
When selecting the desired unit:
<You can select either “M (Meter)” or “F (Feet)”. Once selected, the distances are automatically changed in the selected unit.
When setting the distance:
<You can set the distance within the range of 0.0 to 9.0 meters in 0.3 meter intervals (or 1 to 30 feet in 1 feet intervals).
Crossover frequency
You should select the crossover frequency.
When speakers are set to “S (Small)”, be sure to set their crossover frequency correctly according to their frequency characteristics.
When speakers are set to “S (Small)”, low frequencies in those channels that are below the crossover frequency are to output from subwoofer or front speakers set to “L (Large)” (when not using a subwoofer).
Press the SELECT button (5 or b) to select
<You can adjust the crossover frequency within the range of 40 to 200 Hz in 10 Hz steps.
<Refer to the operating instructions of the speakers to be connected. If the frequency range of your speaker is 100 to 20 kHz, the crossover frequency should be set to 100 Hz (or slightly higher).
31