Battery Connection, Battery Configuration

DC Connectors

Battery Connection

Connect your Inverter/Charger to your batteries using the following procedures:

•Connect DC Wiring: Though your Inverter/Charger is a high-efficiency converter of electricity, its rated output capacity is limited by the length and gauge of the cabling running from the battery to the unit. Use the shortest length and largest diameter cabling (maximum 2 gauge) to fit your Inverter/Charger’s DC Input terminals. Shorter and heavier gauge cabling reduces DC voltage drop and allows for maximum transfer of current. Your Inverter/Charger is capable of delivering peak wattage at up to 175% of its rated continuous wattage output

for brief periods of time. See Specifications page for details. Heavier gauge cabling should be used when continuously operating heavy draw equipment

under these conditions. Tighten your Inverter/Charger and battery terminals to approximately 3.5 Newton-meters of torque to create an efficient connection and to prevent excessive heating at this connection. Insufficient tightening of the terminals could void your warranty. See page 2A for battery wiring recommendations.

•Connect Ground: Using a #8 AWG wire or larger directly connect the Main Ground Lug to earth ground. See the Feature Identification section to locate the Main Ground Lug on your Inverter/Charger. All installations must comply with national and local codes and ordinances.

•Connect Fuse: NEC (National Electrical Code) article 551 requires that you connect all of your Inverter/Charger’s positive DC Terminals directly to a UL-listed fuse(s) and fuse block(s) within 18 inches of the battery. The fuse’s rating must equal or exceed the Minimum DC Fuse Rating listed in your Inverter/Charger’s specifications. See Specifications for fuse and fuse block recommendations. See diagrams below for proper fuse placement.

WARNING!

•Failure to properly ground your Inverter/Charger may result in a lethal electrical shock hazard.

•Never attempt to operate your Inverter/Charger by connecting it directly to output from an alternator rather than a battery or battery bank.

•Observe proper polarity with all DC connections.

Battery Configuration

You may connect one or more batteries to your Inverter/Charger in either of the following configurations.

1Parallel connection: The voltage of each connected battery must match the Inverter/Charger's Nominal DC Input Voltage (12V).

2Series connection: The total voltage of all connected batteries must match the Inverter/Charger's

Nominal DC Input Voltage (12V). Example: 6V + 6V = 12V.

Contact Tripp Lite technical support for assistance with battery connection configurations.

	A
12 Volts	12 Volts	APS700HF
		C
		B

1Parallel Connection

		A
	6 Volts	6 Volts	APS700HF
	6 Volts	6 Volts
	B		C
	B
2	Series Connection

ABattery

BUL-Listed Fuse & Fuse Block (mounted within 18 in. of battery) C Large-Diameter Cabling, Maximum 2 Gauge, to Fit Terminals

9 A