Turn the Power Supply Module’s Outlets on

Connection / Start-Up continued

5Turn the Power Supply Module’s Outlets ON

Press and hold the “Power” button* for one second. The alarm will beep once briefly after one second has passed. Release the button. The “Power” LED* will illuminate to indicate that the Power Supply Module’s outlets are ON. The Battery Charge LED Meter* will indicate the approximate charge level of the connected Battery Module.

* Located on the Remote User Interface (RUI).

6Plug Your AC Equipment into the Power Supply Module’s Outlets

The Power Supply Module provides filtered, pure sine-wave 120V AC power for a variety of equipment—computers, monitors, diagnostic devices, scanners and more. You will overload the Power Supply Module if the total VA ratings for all the equipment you connect exceeds 200VA (the Power Supply Module’s continuous output capacity).*

*To find your equipment’s VA ratings, look on their nameplates. If the equipment is listed in amps, multiply the number of amps by 120 to determine VA. (Example: 1 amp x 120 = 120 VA).

7OPTIONAL—Install PowerAlert Data-Saving Software

This connection is optional. The Power Supply Module and Battery Module will function properly without this connection. Using the included cable*, connect the Power Supply Module’s USB port to the USB port on any laptop or desktop computer mounted on the mobile cart. Insert the included PowerAlert CD and load the version of PowerAlert appropriate for the computer’s operating system. Follow the setup and configuration screens for your specific application.

*If desired, you can substitute standard USB cable in place of the included cable.