Tripp Lite 120/208V owner manual Terminals

Page 14

7. Adding or Replacing Internal Batteries (continued)

6Remove the fuse block bracket.

7Slide the battery string with the RED cable into an empty slot within the battery compartment as shown. Make sure that the string is

oriented as shown in the diagram 7A .

Note: If the auxiliary battery connector is in the way, remove its mounting screw and position the cable to allow adequate room to add the battery strings 7B .

8Slide the battery string with the BLACK cable next to it (on the left) in the empty slot as shown. Make sure that the string is oriented as shown in the diagram 8A .

9Replace the fuse block bracket. Make sure printing on bracket is oriented so it is readable.

6
7
TERMINALS
7A
7B
8
TERMINALS
8A
9

14

Image 14

Contents Table of Contents Intelligent True On-Line UPS SystemsImportant Safety Warnings UPS Location WarningsControl Panels Front PanelBattery Access Panel Cover Removed Adding or Replacing Internal Batteries for detailsRear Panel CommunicationsInstallation Risk of Product Damage and Serious Personal InjuryOperation Normal Conditions Initial Battery ChargingSelf-Testing Turning the UPS OnOperation On Bypass-Voltage Out Of Range Operation Special ConditionsLCD Display Select Button Operation Under Shutdown Operation Of Manual Bypass SwitchInverter On Warnings AS-400 Interface CommunicationsRS-232 Interface Dry Contact InterfaceBattery Packs are Heavy Remote Emergency Power Off EPODo not Remove Battery Sleeve Check Battery Pack Voltage BEFORE COMPLETING InstallationInternal Battery Pack Wiring Diagram Adding or Replacing Internal Batteries Terminals Fuse Replacement Warranty & Warranty Registration Observe Proper PolaritySpecifications Model SU20K3/3Model SU30K3/3