Standard Installation

Note:

1.Test to make sure that the entire installation works properly before pulling cables through ceilings/walls.

2.24AWG, Solid Wire Cat5e/6 cable, such as Tripp Lite’s N202-Series, is required to achieve maximum distance and resolution.

3.The diagram below shows a B126-2X2 installation, but installation will be the same for the B126-4X4, except for the number of ports.

4.The back panel of the B126-4X4 contains an IR port which has been capped off. This port is intended for future use, and does not currently function.

B126-1A0

Cable Box	Up to 125 ft. at 1080p @ 60Hz
or DVR	Up to 175 ft. at 1080i @ 60Hz

Blu-Ray™

Up to 50 ft. at 1080p @ 60Hz Up to 75 ft. at 1080i @ 60Hz

Computer

B126-2x2

B126-1P0

1Make sure all devices being connected are turned off.

2Optional: Connect the 3.5 mm to DB9 adapter to the RS232 serial port on the switch, and then to the DB9 serial port on the computer you will be using to control it with.

3Connect the first HDMI source to the port on the switch marked Source A.

4Repeat step 3 to connect additional HDMI sources to the remaining ports.

5Connect the external power supply to the switch and plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU), or Uninterruptible Power Supply (UPS). When receiving power, the following LEDs will illuminate: The Green Power LED, The Orange Source LEDs (for the Source ports that have devices connected to them), and the Green RJ45 Output LEDs. A Green LED will also illuminate to indicate the source that is being transmitted to each Output port.

6Using Cat5e/6 cable, connect the RJ45 port marked Output 1 to a B126-Series remote receiver unit.

13-11-140 93-32BB.indd 5

11/19/2013 4:57:40 PM