Tripp Lite B126-2X2, B126-4X4 owner manual 13-11-140 93-32BB.indd 11/19/2013 45741 PM

Standard Installation

7Repeat step 6 to connect additional B126-Series remote receiver units to the remaining ports.

8B126-1A0 and B126-1A0-WP-1 only: Connect the external power supply to the active remote receiver unit, and plug it into a Tripp Lite Surge Suppressor, PDU or UPS. When receiving power, the Green RJ45 LED on the B126-1A0, and the Green Power LED on the B126-1A0-WP-1, will illuminate.

9Repeat step 8 for each additional active remote receiver unit in the installation.

10Connect the remote receiver unit to a monitor using a Tripp Lite P568- Series High-Speed HDMI cable. If you have a B126-1P0, connect its built-in HDMI connector to a monitor. When connected to and receiving power from a monitor, the Green RJ45 LED on the B126-1P0, and the Green Power LED on the B126-1P0-WP-1, will illuminate.

11Repeat step 10 for each additional remote receiver unit in the installation.

12Turn on the power to the connected devices. The Orange RJ45 LEDs on the B126-2X2, B126-4X4 and B126-1A0, and the Orange Activity LED on the B126-1A0-WP-1, will illuminate. The video image should now be displayed on the connected monitors.

13B126-1A0 and B126-1A0-WP-1 only: If necessary, use the

Equalization control to adjust the video image.

Note: An improper Equalization setting can cause the monitor not to display an image at all. Try each setting until an acceptable image is displayed.

14Press the switch next to each set of Output LEDs to switch the source being displayed on the corresponding Output monitor. You can also use the included remote control to switch between sources. As with the switch next to the Output LEDs, press the button on the remote

control of the desired Output port to switch the source being displayed.

Note: The same 4 button remote control comes with both the B126-2X2 and B126-4X4. Buttons 3 and 4 will not be used for the B126-2X2.

See the RS232 Serial Control section in this manual for details on controlling the switch using Terminal Emulation Software.

6

13-11-140 93-32BB.indd 6 11/19/2013 4:57:41 PM