Remote Repeater Installation
5Connect the external power supply to the switch and plug it into a Tripp Lite Surge Suppressor, PDU, or UPS. When receiving power, the following LEDs will illuminate: The Green Power LED, the Orange
Source LEDs (for the Source ports that have devices connected to them), and the Green RJ45 Output LEDs. A Green LED will also illuminate to indicate the source that is being transmitted to each
Output port.
6Using Cat5e/6 cable, connect the RJ45 port marked Output 1 to the RJ45 input port of a
7Connect a monitor to the HDMI output port on the repeater using a Tripp Lite
8Connect the external power supply to the repeater and plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The Green Power LED and the Green RJ45 LEDs illuminate to indicate the unit is receiving power.
Add up to three repeaters per channel, for a total of 4 displays (an active remote receiver should be the last unit in a channel). To connect additional repeaters, proceed to step 9. To finish your installation with a
9Using Cat5e/6 cable, connect the RJ45 output port on the first repeater to the RJ45 input port on a second repeater.
10Connect a monitor to the HDMI output port on the repeater using a Tripp Lite
11Connect the external power supply to the repeater and plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The Green Power LED and the Green RJ45 LEDs illuminate to indicate the unit is receiving power.
To add a third repeater, repeat steps 9 through 11. To finish your installation with a
8
11/19/2013 4:57:42 PM |