Configuration
Front View
6
7
10
12
8
11 9
1 2 3 4 5
Figure 2 NetCommander KVM Buttons
13
Figure 1 NetCommander KVM front panel
1Auto: When the LCD Menu is closed, pressing the AUTO button will perform an Auto Adjust on the monitor screen. When the LCD Menu is open, pressing the AUTO button will bring you back to the previous screen/selection. If the LCD Menu cannot go back any further, the AUTO button will close down the menu.
2Menu: When the LCD Menu is closed, pressing the MENU button will open it. When the LCD Menu is open, pressing the MENU button will select a highlighted option.
3On/Off Button: Pressing this button will turn the monitor screen on or off.
4< : When the LCD Menu is open, pressing the < button will move the highlight bar to the left. When modifying a selected option, pressing the < button will decrease the option.
5> : When the LCD Menu is open, pressing the > button will move the highlight bar to the right. When modifying a selected option, pressing the > button will increase the option.
6Handle: Pull to slide the module out; push to slide the module in.
719" LCD Monitor: After sliding the module out, flip up the cover to access the LCD monitor, keyboard and touch pad.
8Keyboard
9Slide Release: Mechanism to lock the drawer closed when the console is not in use.
Prevents it from accidentally sliding open. To slide the console out, you must first release it by moving the tab sideways.
10Rackmounting Brackets: There are rackmount brackets to secure the chassis to a system rack located at each corner of the unit.
11
12LCD Display Controls: The LCD OSD controls located here control the position and picture settings of the LCD display. See LCD OSD configuration for details.
13Railway Release Tabs: When the drawer is completely pulled out to the end, the railway system will lock. Push the release tabs on both sides to release the drawer so that it can be pushed back in.
4