Moxa Technologies NPort 6110 user manual Modbus Serial Settings

Page 33

Modbus Serial Settings

The Modbus Serial Settings page is used to configure NPort 6110’s DB9 Male port. You can configure Interface Mode, Baud Rate, Parity, Data Bits, Stop Bit, Flow Control, and UART FIFO.

NOTE To modify the settings on this page, you must first checkmark the Change Modbus Settings box at the top of the Modbus Settings page.

4-12

Image 33

Contents NPort 6110 Modbus/TCP To Serial Communication Gateway NPort 6110 Modbus/TCP To Serial Communication Gateway Moxa Internet Services Table of Contents Page Overview IntroductionPowerful operation modes for versatile Modbus applications FeaturesLAN Product SpecificationsEnvironmental Package ChecklistFront/Top/Rear/Bottom Panel Views Power Connection Serial InstallationGetting Started Software Installation Ethernet InstallationPage Page Page Page DIN-Rail HousingWall Mount Typical Modbus Applications Connect all Modbus devices over the Ethernet network… Link the Serial Master device with Ethernet Slave devices… Configuring Modbus Gateway Starting Modbus Gateway Configurator Searching for NPort Broadcast SearchSpecify by IP Address Modify Configuration Network Settings Alphanumeric Modbus SettingsPage Page Advanced Modbus Settings IP address Page Modbus Serial Settings RTS/CTS Uart Fifo Password Upgrade Firmware Other FunctionsUnlock Page Start Log Monitor Remote Monitoring and ManagementPage ID No. mismatch TroubleshootingDB9 Male Pinouts Pin AssignmentsDeclaration of Conformity NPort 6110 Modbus Gateway Problem Report FormReturn Procedure