Philips HTS8100 quick start Radio Operations, Tuning to radio stations, Presetting radio stations

Radio Operations

Before you start ...

Make sure the FM and AM/MW antennas are connected.

Tuning to radio stations

A Press SOURCE repeatedly until ‘RADIO FM’ appears on the display panel (or press RADIO on the remote control).

B Press cursor left/right keys briefl y on the remote control to start tuning.

‘SEARCH > or <’ appears on the display panel until a radio station with suffi cient signal strength is found.

C Repeat step B if necessary until you fi nd the desired radio station.

D To fi ne-tune the reception of a weak station, press the cursor up/down keys briefl y and repeatedly until optimal reception is found.

E To switch between FM stereo and FM mono mode, press AUDIO on the remote control.

Helpful Hint:

–If the FM radio station is transmitting RDS (Radio Data System) data, the RDS name will be displayed and stored.

Presetting radio stations

You can store up to 40 FM and 20 AM preset radio stations in the memory. There are three different ways to program the radio stations:

–Using auto install (for fi rst time setup only)

–Using automatic preset

–Using manual preset

Helpful Hints:

–This unit exits presetting mode if no button is pressed within 20 seconds.

–If no stereo signal is detected or less than

5 (fi ve) stations are detected during radio installation, ‘CHECK ANTENNA’ appears.

Using auto install

When you access the ‘RADIO’ mode for the very fi rst time, you will be prompted to install the radio stations. With this feature, you can install all the available radio station automatically with one touch of button.

RADIO

English

AMBISOUND

A Press RADIO.

‘AUTO INSTALL ... PRESS PLAY’ appears.

45