A – Fast!UTIL | Configuration Settings |
Some new system BIOSs support selectable boot, which supersedes the Fast!UTIL selectable boot setting. To boot from an FC hard disk attached to the QLA23xx board, select the QLA23xx board FC hard disk on the system BIOS.
NOTE: This option applies only to hard disks; it does not apply to tape drives and other nondisk devices.
A.2.3
Restore Default Settings
The Restore Defaults option from the Configuration Settings menu restores the QLA23xx board default settings.
A.2.4
Raw NVRAM Data
This option displays the adapter’s NVRAM contents in hexadecimal format. This is a QLogic troubleshooting tool; you cannot modify the data.
A.2.5
Advanced Adapter Settings
From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter Settings. The default settings for the QLA23xx board are listed in table
Table A-2. Advanced Adapter Settings
Setting | Options | Default |
|
|
|
Execution Throttle | 16 | |
Fast Command Posting | Enabled, Disabled | Disabled |
>4GByte Addressing | Enabled, Disabled | Disabled |
Luns per Target | 0, 8, 16, 32, 64, 128, 256 | 8 |
Enable LIP Reset | Yes, No | No |
Enable LIP Full Login | Yes, No | Yes |
Enable Target Reset | Yes, No | No |
Login Retry Count | 8 | |
Port Down Retry Count | 8 | |
Drivers Load RISC Code | Enabled, Disabled | Enabled |
Enable Database Updates | Yes, No | No |
Disable Database Load | Yes, No | No |
IOCB Allocation | 256 buffers | |
Extended Error Logging | Enabled, Disabled | Disabled |
|
|
|