A – Fast!UTIL | Configuration Settings |
■Disable Database Load. When enabled, the device database is read from the Registry during driver initialization. When disabled, the device database is created dynamically during driver initialization. The default is No.
NOTE: This option usually applies to the Windows NT and Windows 2000 operating environments.
■IOCB Allocation. This setting specifies the maximum number of buffers from the firmware’s buffer pool that are allocated to any one port. The default is 256 buffers.
■Extended Error Logging. This setting provides additional error and debug information to the operating system. When Enabled, events are logged into the Windows NT/Windows 2000 Event Viewer. The default is Disabled.
A.2.6
Extended Firmware Settings
From the Configuration Settings menu in Fast!UTIL, select Extended Firmware Settings. The default settings for the QLA23xx board are listed in table
Table A-3. Extended Firmware Settings
Setting | Options | Default |
|
|
|
Extended Control Block | Enabled, Disabled | Enabled |
RIO Operation Mode | 0, 1, 2, 3, 4 | 0 |
Connection Options | 0, 1, 2 | 2 |
Class 2 Service | Enabled, Disabled | Disabled |
ACK0 | Enabled, Disabled | Disabled |
Fibre Channel Tape Support | Enabled, Disabled | Disabled |
Fibre Channel Confirm | Enabled, Disabled | Disabled |
Command Reference Number | Enabled, Disabled | Disabled |
Read Transfer Ready | Enabled, Disabled | Disabled |
Response Timer | 0 | |
Interrupt Delay Timer | 0 | |
Data Rate | 0, 1, 2 | 0 |
|
|
|