Configuration Settings | A – Fast!UTIL |
A.2.1
Host Adapter Settings
From the Configuration Settings menu in Fast!UTIL, select Host Adapter Settings. The default settings for the QLA23xx board are listed in table
Table A-1. Host Adapter Settings
Setting | Options | Default |
|
|
|
Host Adapter BIOS | Enabled, Disabled | Disabled |
Frame Size | 512, 1024, 2048 | 2048 |
Loop Reset Delay | 5 seconds | |
Adapter Hard Loop ID | Enabled, Disabled | Disabled |
Hard Loop ID | 0 | |
|
|
|
■Host Adapter BIOS. When this setting is Disabled, the ROM BIOS on the QLA23xx board is disabled, freeing space in upper memory. This setting must be enabled if you are booting from an FC hard disk attached to the QLA23xx board. The default is Disabled.
■Frame Size. This setting specifies the maximum frame length supported by the QLA23xx board. The default size is 2048, which provides maximum performance for
■Loop Reset Delay. After resetting the loop, the firmware refrains from initiating any loop activity for the number of seconds specified in this setting. The default is 5 seconds.
■Adapter Hard Loop ID. This setting forces the adapter to attempt to use the ID specified in the Hard Loop ID setting. The default is Disabled.
■Hard Loop ID. If the Adapter Hard Loop ID setting is enabled, the adapter attempts to use the ID specified in this setting. The default ID is 0.
A.2.2
Selectable Boot Settings
The Selectable Boot Settings option is accessed from the Configuration Settings menu. If you enable this option, you can select the node name from which you want to boot. Once enabled, this option forces the system to boot on the selected FC hard disk, ignoring any IDE hard disks attached to your system. If you disable this option, the system looks for a boot device (as selected in the system BIOS). In disabled mode, the Boot ID and Boot LUN parameters have no effect.