Moxa Technologies 2140 user manual Weekly schedule, Level

by time interval.

Administrators can use combinations of options on the application web page to perform various useful security applications. Although most settings will be done automatically by the Application Wizard, administrators can also make adjustments to the settings from this page.

To set up the 4 applications that VPort 2140 Video Server provides, administrators must have a certain level of knowledge about the setting items listed in the Application web page. Below is the table that separates the setting items into 4 levels. Higher-level settings will not be activated unless lower-level items are checked.

Level 1	Level 2	Level 3	Level 4
□Weekly schedule		□Sun □Mon □Tue □Wed □Thu □Fri □Sat
		snapshots begin at [hh:mm:ss]
□All the time except		snapshots stop at [hh:mm:ss]
	□Enable the external script file to ignore the following settings
for the above schedule
	□Event operation	□Show alert in image
		Trigger	Motion Detected on:
		condition	□Video 1 □Video 2 □Video 3 □Video 4
			DI condition:
			DI 1: Disable, High, Low, Rising, Falling
			DI 2: Disable, High, Low, Rising, Falling
			DI 3: Disable, High, Low, Rising, Falling
			DI 4: Disable, High, Low, Rising, Falling
		Trigger action	Delay □ second(s) to trigger output alarm
		□ Send
			DO condition:
		snapshot while	DO 1: Disable, Open, Close
		trigger	DO 2: Disable, Open, Close
		condition(s)	Snapshot on:
		match	□Video 1 □Video 2 □Video 3 □Video 4
			Take □ snapshot(s) with □ tenth seconds
			interval after the event
	□Sequential mode		Snapshot every □ tenth seconds
	□Send snapshot by email
	□Send snapshot by	□FTP put snapshots with date and time suffix
	FTP

Weekly schedule

The Weekly schedule is provided for daily security applications. Administrators can select any weekday from Monday to Friday with the daily schedule set from 08:00 am to 20:00 pm when no one is available to perform event checking. If the security system is installed in an office for which no one is present on nights or weekends, administrators can still set the time period as above, from 08:00 am to 20:00 pm, but remember to select All the time except for the above schedule to let the program run during nights and weekends.

Either “Weekly schedule” or “All the time except for the above schedule” must be selected, or the applications described in the following sections will not work properly.

4-14 VPort 2140 User’s Manual