Moxa Technologies CP-168U user manual Software Installation

Software Installation

will now appear in the MOXA Smartio/Industio Configuration Panel dialog box, as shown below.

14.Click [OK] in the MOXA Smartio/Industio Configuration Panel to return to the Network dialog box, and then click [OK] to exit the Network dialog box.

15.Restart the PC.

Note! The driver configuration will NOT take effect until you restart the PC.

Note! Double check that all Smartio CP-168U board components—the control board—are connected and fastened tightly to make sure that the system and the driver can start up successfully.

Once the system restarts, you may check the event log issued by the MOXA driver to see if the board’s ports have been initialized successfully.

Enter the [Administrative] group, click the [Event Viewer] icon, and then select [Log] and [System] to check a message similar to “MOXA CP-168U board, with first serial port COM3, has been enabled” for each newly configured board.

Note! If an error message similar to “Cannot find any configured MOXA Smartio/Industio series board!” pops up, refer to the Troubleshooting chapter for possible solutions.

Once the board and the driver are installed and the driver restarts successfully, you can start

Smartio CP-168U User’s Manual 3-5