NPort 5110 Series User’s Manual | Web Console Configuration | |||
| Port alias |
|
|
|
| Setting | Factory Default | Necessity |
|
| 1 to 15 characters | None | Optional |
|
| (E.g., |
|
|
|
“Port alias” is included to allow easy identification of the serial devices that are connected to NPort 5110’s serial port.
Serial Parameters
ATTENTION
Check the serial communication parameters in your Serial Device’s user’s manual. You should set up NPort 5110’s serial parameters with the same communication parameters used by your serial devices.
Baud rate
Setting | Factory Default | Necessity |
110 bps to 230.4 Kbps | 115.2 Kbps | Required |
Data bits |
|
|
Setting | Factory Default | Necessity |
5, 6, 7, 8 | 8 | Required |
When the user sets Data bits to 5 bits, the Stop bits setting will automatically change to 1.5 bits.
Stop bits
Setting | Factory Default | Necessity |
1, 1.5, 2 | 1 | Required |
Stop bits will be set to 1.5 when Data bits is | set to 5 bits. |
|
Parity |
|
|
Setting | Factory Default | Necessity |
None, Even, Odd, Space, Mark | None | Required |
Flow control |
|
|
Setting | Factory Default | Necessity |
None, RTS/CTS, DTR/DSR, Xon/Xoff | RTS/CTS | Required |
FIFO |
|
|
Setting | Factory Default | Necessity |
Enable, Disable | Enable | Required |
NPort 5110’s serial ports provide a
Interface
Model | Port | Settings | Factory Default | Necessity |
NPort 5110 | 1 | Required |