4.9Setting the RUN Mode
4.9.1When to Set the RUN Mode
Setting the BM85 to its RUN mode applies the parameters you have assigned making the unit ready for operation on the Modbus Plus network and at its Modbus ports.
When the BM85 is in its RUN mode it will become active in your application as soon as power is applied to the unit.
Caution:"You must complete the internal configuration of the BM85 before making the unit active in your application both on the Modbus Plus network and at its serial ports
If you are installing a BM85 that was previously configured for another application another network or a different node the unit will still be retaining its previous configuration setup You must not connect the unit into the current application and apply operating power to the unit until you have reconfigured it for the current application
4.9.2How to Set the RUN Mode
Before you set the unit to RUN mode verify that you have setup its Modbus port parameters and Modbus Plus node address as described in this chapter.
Turn off power to the Bridge Multiplexer and set its configuration switch 8 to the RUN position. Refer to Figure 15 for the configuration switch location and setting.
If you have set the BM85 configuration correctly for a specific installation site you can transport the unit to the site and install it.
The RUN mode will be set when power is reapplied to the BM85.
68 Configuring the Programmable Models | 31007492 |