3.3 Configuration Checklist
You have a specific sequence of actions for configuring your M85.
Use these items as your checklist:
1.Select a terminal and cable. Refer to Appendix A for a listing of compatible terminal devices and cables. Select a terminal and cable that you will use for the configuration.
2.Determine the Modbus port parameters. Refer to Section 3.4 Modbus Port Parameters. Determine the parameters you want to use for each Modbus port:
h Port Type
h Slave Device Address
h ommunication Parameters h Port Priority
h Link Timeout h Modem ooster
h Modbus Plus Address Table.
3.Configure the Modbus ports. Turn off all power to the M85. Refer to Section 3.5 Configuring the Modbus Ports.
onnect your terminal to the port you will use for configuration. Start your terminal and any emulation program you are using.
Set the switches to allow the configuration and power up the M85. Use the configuration screens and keyboard to configure the unit.
4.Set the Modbus Plus address. Refer to Section 3.11 Setting the Modbus Plus Address. Set the M85 rear panel address switches to its node address on your Modbus Plus network.
5.Set the RUN Mode. Refer to Section 3.12 Setting the RUN Mode. Turn off all power to the M85. Set its rear panel switch to the RUN mode. onnect the unit to the Modbus Plus network and to the Modbus devices at its installation site before reapplying power.
28 Configuring the Modbus Models | 31007492 |