Schneider Electric manual Simatic S7 Ethernet

Page 11

SIMATIC S7 Ethernet

*2 PLC supports a maximum of 64 connections. Because 2 connections are required for each target machine, one for Fetch and one for Write, the PLC can support up to 32 target machines.

*3 The direct connection to the Ethernet Interface on these CPUs only supports the “OP Communication” type. The FETCH/WRITE protocol will not work.

Note:

zUse a 100BASE-TX connection for iPC Series, XBTGTW Series, XBTGK Series, XBTGC2000 Series or higher, XBTGT2000 Series or higher, XBTGH2000 Series, XBTGT1005 Sereis, and HMISTU Series target machines.

11

Image 11

Contents Siemens AG Page Table of Contents Page Important Information Safety InformationPlease Note Validity Note About the BookAt a Glance Document ScopeUser Comments Product Related InformationWhats in this Chapter? Simatic S7 EthernetSubject of this Chapter Connection System StructureOverview Simatic S7 Ethernet Fetch/Write Supported Device AddressesS7-300/400 Series S7-200 Series Gap Span Consecutive Equipment AddressesScreen example of I/O Manager Configuration Manager ConfigurationS7-200 Series Screen Description Equipment ConfigurationFetch Fetch/Write Screen DescriptionS7-300/400 Series Screen Description Screen example of Device Address Configuration Device Address ConfigurationKeypad Simatic S7 Ethernet