Sun Microsystems Interface Adapter manual Configuring the Software, To Test the Installation

5.After the system reboots, verify the installation by typing the following commands:

#/usr/bin/pkginfo grep SUNWhsip

system	SUNWhsip	SunHSI/P Driver for PCI
system	SUNWhsipm	SunHSI/P Man Pages for PC
system	SUNWhsipu	SunHSI/P Utilities for PCI

#modinfo grep HSIP

126 7bb24000 17708 150 1 HSIP (PT-PCI334 Driver)

#grep HSIP /etc/path_to_inst "/ssm@0,0/pci@18,700000/pci1214,334a@2" 0 "HSIP"

The output shows that the packages are installed, the driver is loaded, and that the software is mapped to the adapter.

▼To Test the Installation

●Type the following command (replace n with the adapter port you are testing):

#hsip_loop -c 100 -l 2048 -s 2048000 -t 1 hihpn

This command runs an internal loopback test. For more information, see the hsip_loop(1M) man page.

Configuring the Software

To configure the adapter for the Point-to-Point Protocol (PPP), see “To Configure for Point-to-Point Protocol” on page 15. Also refer to the Solaris System Administration Guide: Network Services documentation for the version of Solaris that you are running. These documents are available from the following web site:

http://docs.sun.com/

To configure the adapter for the X.25 9.2 protocol, refer to the Solstice X.25 9.2 Administration Guide (806-1234). The X.25 9.2 documents are available from the following web site:

http://docs.sun.com/

14 Sun PCI High Speed Quad Port Serial Interface Adapter User’s Guide • December 2005