Sun Microsystems FC-100 Routing the Power Cord, Connect the fiber optic cable to the Gbic

■To insert a GBIC that has a bail, slide the GBIC into the available port with the bail in the unlocked (right) position. Once the GBIC is firmly seated in the port, move the bail left into the locked position.

Slot

Bail

Notches

Key (on side)

FIGURE 2-4Installing a GBIC That Has a Bail and Fiber Optic Cable

3.Connect the fiber optic cable to the GBIC.

Fiber optic cable connectors are keyed to prevent improper insertion; they can only be installed as shown in FIGURE 2-3and FIGURE 2-4.

4.Route the fiber optic cable to an initiator or target. Refer to the documentation that came with the device.

5.Connect the fiber optic cable to a GBIC in the initiator or target. Refer to the documentation that came with the device.

2.3.6Routing the Power Cord

If you are installing the hub along with Sun StorEdge A5000 Disk Arrays in a Sun StorEdge Expansion Cabinet, refer to the Sun StorEdge A5000 Disk Array Hardware Configuration Guide, part number 805-0264-12 (or later), for cable routing.

2-6Sun StorEdge FC-100 Hub Installation and Service Manual • September 1998