C H A P T E R 6
Installing Windows Server 2003
This chapter describes how to install the Windows Server 2003 operating system onto a Sun Blade X6250 server using the Windows Server 2003 media.
Installation Requirements
Before beginning the operating system installation, make sure that the following requirements are met for all installation methods:
■Complete the procedures in the previous chapters of this document (Chapters 2 through 5).
■When using the Floppy Disk Local mass storage drivers installation method, connect the USB floppy drive directly to one of the USB ports on the dongle cable provided with the server. Other USB devices should be connected to a USB hub attached to the other dongle cable USB port.
■If you are using an optional Sun Blade RAID 5 Expansion Module (Adaptec™- based), choose one of the following installation options that best matches your needs:
■If you want to include your boot disk as part of a RAID configuration, you must configure your RAID volume(s) using the controller’s array cofiguration utility before you install the Windows operating system. The controller’s BIOS configuration utility is accessible during the server boot process by pressing Ctrl+A when prompted.
■If you have a clean boot disk (no partitions) and do not want to make it part of a RAID, you must still create an array volume on it using the controller’s BIOS configuration utility (accessible by pressing Ctrl+A when prompted during server boot) in order for Windows to be able to access the disk. This must be done before you install the Windows operating system. For more information, see Appendix B.
29