Paradyne Broadband Services Switch, BSX8000-5 NMS Management Configuration, Parameter Description

Page 9

NMS Management Configuration

Use the Management Configuration screen to set the unit’s IP address and other management parameters.

To configure management parameters:

1.From the home screen, click on the Management Config button. The Management Configuration screen appears.

2. Select or enter the following parameters:

Parameter	Description

IP Address	Specify the management IP address for the DSLAM.

Subnet Mask	Specify the subnet mask for the IP address.

Gateway	Specify the first-hop gateway address.

EtherType	Select the type of packets supported by your router.
	This is used only for backbone VLAN (Q in Q) traffic.

Inband MGMT	Check this box if you will use inband management
	(that is, you will allow the device to be contacted by
	ports other than the MGMT port)..

VLAN Id	Specify a VLAN identifier for inband management.

Priority	Specify a priority (0–7) for inband management traffic.

BSX8-A2-GZ40-10

March 2005

Image 9

Contents Software and Firmware License Agreement ContentsPage BSX8000-5 Overview Product Documentation OnlineRelease Notes Unpacking and Inspecting the Equipment Installing a Micro Interface Module MIM in the BSX8000-5Connect the MIM to the Network Installing the BSX8000-5 in a BLCMIM-10/100 MIM-2000FBLC Management Web Interface NMSMIM-4000F Configuring Your Windows PC to Communicate with NMS NMS home page appears Parameter Description NMS Management ConfigurationCLI System Requirements Command Line Interface CLICLI Commands Connecting a PC DirectlyCLI Commands 1 Description Launching the Terminal Emulation ProgramClearnvram CLI Commands 2 DescriptionLED Indicators LED States and MeaningsState Indication Additional Information 10/100/1000BaseT Connectors 100/1000 Pinouts SignalDB9 to RJ45 Adapter Pinouts Regulatory Compliance for Class a Equipment Warranty, Sales, Service, and Training InformationUS Federal Communications Commission FCC Industry Canada EuropeBSX8-A2-GZ40-10