1.0 INSTALLATION
CAUTION Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when handling this equipment.
1.1 Unpack and Inspect the Equipment
The following components should be included:
1IPD4000E with 1 fan module and 12 blank plates
4Rubber Bumper Screws
2Rack Mount Brackets (either 19" or 23", as ordered)
10#6 Phillips Bracket Screws
8#10 Phillips Rack Screws
8#12 Phillips Rack Screws
CHASSIS SPECIFICATIONS
7" High x 17" Wide x 18" Deep (17.8 cm x 43.2 cm x 46 cm) 28 lbs (12.73 kg)
If there is visible damage, do not attempt to connect the device. Contact Customer Support: customers in Europe, the Middle East and Africa please call
1.2 Select a Site for Installation
NOTE The IPD4000E is designed for installation in a Restricted Access area where admittance is limited to trained and authorized service personel.
OPERATING REQUIREMENTS
Operating Temperature:
Humidity: 5% to 95%,
Altitude:
1.2.1 Tabletop
Insert the four [4] provided rubber bumper screws into the mounting holes at the bottom four corners of the IPD4000E chassis for surface grip. Position and secure all connecting cables such that they will not become a tripping hazard or pull loose from the chassis. Ensure that the air supply vents around the top and bottom edges of the chassis are not blocked.
IPD4000E BOTTOM VIEW
RUBBER BUMPER
SCREW
Side 
Top
Front | Rear |
IPD4000E Installation Instructions | Page 3 of 17 |