Paradyne IPD4000E installation instructions Detach the Velcro Strap

EXCEPTION For the TIM1500-24 and EIM2000-24 interface modules, the A connectors provide the subcriber connections for ports 1-12 and the B connectors provide the subscriber connections for ports 13-24.

1.7.2 Detach the Velcro Strap

Detach the Velcro Strap from the female RJ21 connector port: lift the Velcro tab from the bottom and pull the strap upward to open, leaving it looped under the right side of the connector frame.

FEMALE RJ21 CONNECTOR A

FOR INTERFACE MODULE SLOT 3

1.7.3 Position the RJ21 Connector

Slide the male RJ21 connector of your interface cable underneath the Velcro, from the left, and press it firmly into the female RJ21 connector port on the chassis.

MALE RJ21 CONNECTOR OF

YOUR INTERFACE CABLE

1.7.4 Secure the RJ21 Connector

Pull the Velcro strap upward, making sure that it is snug against the connector, then pull the strap back down, such that the Velcro layers stick to one another across the top of the connector.

IPD4000E Installation Instructions 220-0000097 rev01 Page 12 of 17