Patton electronic 1094 user manual Radio and TV Interference, CE Notice, Service

Page 2

1.0 WARRANTY INFORMATION

Patton Electronics warrants all Model 1094 components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.

This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modifi- cation. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequen- tial damages arising from the use of or inability to use this product. Patton Electronics specifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user.

1.1 RADIO AND TV INTERFERENCE

The Model 1094 generates and uses radio frequency energy, and if not installed and used properly—that is, in strict accordance with the manufacturer's instructions—may cause interference to radio and tele- vision reception. The Model 1094 has been tested and found to com- ply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection from such interference in a commercial installation. However, there is no guarantee that interfer- ence will not occur in a particular installation. If the Model 1094 does cause interference to radio or television reception, which can be deter- mined by removing power from the unit, the user is encouraged to try to correct the interference by one or more of the following measures: moving the computing equipment away from the receiver, re-orienting the receiving antenna and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and receiver are on different branches).

1.2 CE NOTICE

The CE symbol on your Patton Electronics equipment indicates that it is in compliance with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the Union European (EU). A Certificate of Compliance is available by contacting Technical Support.

1.3 SERVICE

All warranty and non-warranty repairs must be returned freight pre- paid and insured to Patton Electronics. All returns must have a Return Materials Authorization number on the outside of the shipping contain- er. This number may be obtained from Patton Electronics Technical Service at:

TEL: (301) 975-1007

Email: support@patton.com.

www:http://www.patton.com

NOTE: Packages received without an RMA number will not be accepted.

Patton Electronics’ technical staff is also available to answer any questions that might arise concerning the installation or use of your Model 1094. Technical Support hours: 8AM to 5PM EST, Monday through Friday.

1

2

Image 2
Contents User Manual CE Notice ServiceRadio and TV Interference TEL 301 Email support@patton.comDescription FeaturesExternal DIP Switch Settings S1 Summary Table Connection to the Twisted Pair Interface Twisted Pair Connection Using RJ-45Signal Changing Quickconnect Modules Signal PIN#Connection to the Serial Port AC Power Connection Reconfiguring the X.21 Quickconnect ModuleConnection to the Power Source Connection to a DTE DeviceLED Status Monitors POWER-UPDiagnostics Local Analog Loopback LALRemote Digital Loopback RDL Local Digital Loopback LDLPatton Electronics Model Specifications 4 V.52 BER Test GeneratorPatton Electronics Model Cable Recommendations Wire Gauge Capacitance ResistanceAlways use twisted pair wire-this is not an option Patton Model # DescriptionPin # Signal Patton Electronics Model 1094 Interface PIN AssignmentsPatton Electronics Model Interface PIN Assignment