Vlink, 1058DVRC 1058DRC | Patton electronic guide

2.Secure the rear card using the supplied metal screws.

3.Slide the front card into the chassis until you feel resistance as the front card engages the rear card. When that happens, gently push the front card forward until it is fully seated in the card-edge recepta- cle of the rear card (it should click into place).

4.Secure the front card using the captive fasteners.

Note The Model 1001R14 chassis supports “hot swapping” of cards, so it is not necessary to power down the rack when you install or remove a Model 1058 rack card.

VLINK

RJ-45 interface

VLINK

terminal block

Ethernet

Port

		VLINK
		RJ-45 interface
		VLINK
	VLINK	terminal block
	VLINK
VLINK	POTS/ISDN	Port
		POTS/ISDN
		Port
		Ethernet
	Ethernet
Ethernet	1058DVRC
	1058DVRC

1058DRC

Figure 3. Model 1058 rack cards

5.Connect the line interface between the units (refer to section 3.3, “Connecting the Twisted-Pair Line Interface” on page 10)

Note See Figure 3 for the rack card’s panel arrangements.

6.Connect the Ethernet interface (refer to section 3.4, “Connecting the 10/100Base-T Ethernet Interface” on page 11).