PATTON ELECTRONICS CO. | 3040/V35 | INSTALLATION AND OPERATIONS MANUAL |
139001UA
Switch 18 - 1, 2, 3, 7 and 8 to OFF, 4, 5 and 6 to ON
Anti-Stream timer = 2 M bits
Anti-Stream = Disabled
Broadcast Data to Sub-Channels
RX Clock Source = Master
JP4 Thru JP7 Open
HS Option Not Enabled
JP8 thru JP12 to Open
DTR / DSR Not Forced
JP1 Thru JP3 to Installed
Factory Test Jumpers
If the system application requires one or more of the default settings to be changed, it will be necessary to remove the top cover of the enclosure to access and change the DIP switches located on the printed circuit board.
Disassembly
Remove the top cover by removing the phillips head screws located on the left and right sides of the 3040/V35 (CTS MD-V.35/TCB). DTE/DCE switches SW5 through SW14, baud rate Jumpers JP4 through JP7, interface Jumpers JP8 through JP12 and configuration switches SW15 through SW18 are located on the PCB as indicated on the strapping guide in the Appendix of this manual. After the switch selection activity is completed, re-install the top cover BEFORE connecting to a AC power source.
Installation
Select an appropriate location accessible to and within six feet of an AC power outlet, the outlet must have a ground pin receptacle for product warranty. The DCE-to-DTE cabling between each attached device and the 3040/V35 (CTS MD-V.35/TCB) should be “Straight Through”, shielded and terminated with male connectors. Sub-Channels are marked PORT 1 through PORT 4, the Master Port is marked, MASTER DCE/DTE. If any terminal has a priority service mode, ensure it is connected to the port connector designated “PORT 1” on the rear panel of the 3040/V35 (CTS MD-V.35/TCB). Secure other terminals or Modems to be serviced to the remaining “PORT” connectors. Connect the MODEM or TERMINAL to the connector designated “MASTER DTE/DCE”.