Patton electronic 4630 user manual Connecting the 10/100Base-T Ethernet LAN and WAN cables

SmartNode 4630 User Manual 3 • SmartNode installation

Connect the cables in the following order:

The interconnecting cables shall be acceptable for external use

and shall be rated for the proper application with respect to volt-

age, current, anticipated temperature, flammability, and

CAUTION mechanical serviceability.

1.Connect the ISDN terminals and NT to the BRI ports (see section “Connecting ISDN terminals and NT to the SmartNode’s ISDN BRI ports”).

2.Connect the 10/100Base-T Ethernet LAN and WAN (see section “Connecting the 10/100Base-T Ether- net LAN and WAN cables” on page 25)

3.Connect the power mains cable (see section “Connecting the power supply” on page 26)

Connecting ISDN terminals and NT to the SmartNode’s ISDN BRI ports

The SmartNode comes with five ISDN BRI ports located on the rear panel (see figure 2 on page 15). All ports can be connected to the PSTN (ISDN NT) or terminals.

When this device is used in North America, it shall be connected to a Network Termination Device and not connected directly to an outside POTS line.

CAUTION

Note We recommend connecting the PSTN to BRI 0/0 and a terminal to BRI 0/1 to benefit from the lifeline function.

For details on the BRI port pinout and ISDN cables, refer to Appendix C, “Cabling” on page 43 and Appendix D, “Port pin-outs”on page 47.

Connecting the 10/100Base-T Ethernet LAN and WAN cables

The SmartNode 4630 has automatic MDX (auto-crossover) detection and configuration on all Ethernet ports. Any of the ports can be connected to a host or hub/switch with a straight-through wired cable.

1.Connect to the subscriber port of the broadband access modem (DSL, cable, WLL) to ETH 0/0.

2.Connect port ETH 0/1 to your LAN.

For details on the Ethernet port pinout and cables, refer to Appendix C, “Cabling” on page 43 and Appendix D, “Port pin-outs”on page 47.

Installing the gateway router 25