Patton electronic 4630 user manual Voice connectivity, Data connectivity

Page 40

SmartNode 4630 User Manual

B • Specifications

 

 

Note Refer to the software feature matrix for the most up-to-date specifications.

DSP

One or two 4-channel DSP

Voice connectivity

3 or 5 ISDN BRI S0 (S/T), 4-wire RJ45 ports NT/TE configurable per port Point-to-point, point-to-multipoint configurable

Life-line bypass relay between BRI 0/0 and BRI 0/1 ports

ISDN line power can be switched on per software per port

Data connectivity

Two 10/100Base-TX Ethernet ports

All ports full duplex, autosensing, auto-MDX

Voice processing (signalling dependent)

Four or eight full-duplex channels with Voice CODECS:

G.711 A-Law/ -Law (64 kbps)

G.726 (ADPCM 16, 24, 32, 40 kbps)

G.723.1 (5.3 or 6.3 kbps)

G.729ab (8 kbps)

Transparent ISDN data

G.168 echo cancellation (25 ms)

Four or eight simultaneous low-bandwidth voice or T.38 fax calls

DTMF detection and generation

Carrier tone detection and generation

Silence suppression and comfort noise

Adaptive and configurable dejitter buffer

Configurable tones (dial, ringing, busy)

Configurable transmit packet length

RTP/RTCP (RFC 1889)

DSP

40

Image 40 Contents
SmartNode 4630 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Cabling SmartNode 4630 factory configuration List of Figures List of Tables Audience About this guideStructure Precautions Impaired functioningSafety when working with electricity General observationsTypographical conventions used in this document General conventionsChapter contents General informationSmartNode 4630 overview SmartNodeSmartNode 4630 rear panel SN4638100-240 VAC Power SmartNode 4630 front panelBRI B1/B2 Applications overview Introduction Application-Edge intelligence of enterprise communicationApplication-Multi-service Isdn Internet telephony IAD How it worksSmartNode installation Planning the installation Network DiagramSite log Network informationInstalling the gateway router Connecting the 10/100Base-T Ethernet LAN and WAN cables Connecting the power supply Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCConfiguring the desired IP address Factory-default IP settingsLogin Changing the WAN IP addressConnecting the SmartNode to the network LANLoading the configuration optional Additional information Contacting Patton for assistance Contact information Warranty coveragePatton support headquarters in the USA Out-of-warranty service RMA numbersAppendix a Compliance information Safety ComplianceRadio and TV Interference Pstn RegulatoryAuthorized European Representative CE Declaration of ConformityIsdn compliance Appendix B Specifications Voice connectivity Voice processing signalling dependentData connectivity Fax and modem support Voice signallingVoice routing-session router IP services ManagementSystem PhysicalAppendix C Cabling Connecting a serial terminal ConsoleTypical Ethernet straight-through cable diagram EthernetIsdn BRI Appendix D Port pin-outs Console port Isdn BRI 0/0 NT/Net or TE/User portIsdn BRI 0/1 . /3 TE/Usr or NT/Net Appendix E SmartNode 4630 factory configuration Introduction Appendix F End user license agreement End User License Agreement Termination Other licenses
Related manuals
Manual 54 pages 39.68 Kb