Patton electronic 4630 user manual Termination, Other licenses

Page 54

SmartNode 4630 User Manual

F • End user license agreement

 

 

If the Program(s) are acquired by or on behalf of a unit or agency of the United States Government, the Gov- ernment agrees that such Program(s) are commercial computer software or computer software documentation and that, absent a written agreement to the contrary, the Government’s rights with respect to such Program(s) are limited by the terms of this Agreement, pursuant to Federal Acquisition Regulations 12.212(a) and/or DEARS 227.7202-1(a) and/or sub-paragraphs (a) through (d) of the “Commercial Computer Software - Restricted Rights” clause at 48 C.F.R. 52.227-19 of the Federal Acquisition Regulations as applicable.

6. Termination

A)The End User may terminate this agreement by returning the Designated Equipment and destroying all copies of the licensed Program(s).

B)Patton Electronics Company may terminate this Agreement should End User violate any of the provi- sions of section “4. Grant of License” on page 53.

C)Upon termination for A or B above or the end of the Term, End User is required to destroy all copies of the licensed Program(s)

7. Other licenses

The Program may be subject to licenses extended by third parties. Accordingly, Patton Electronics Company licenses the Programs subject to the terms and conditions dictated by third parties. Third party software identi- fied to the Programs includes:

A routing license is included at no charge.

MGCP and VPN capabilities will require the purchase of an additional license.

The LGPL (Lesser General Public License) open source license distributed to you pursuant to the LGPL license terms (http://www.gnu.org/licenses/lgpl.html).

RedBoot (Red Hat Embedded Debug and Bootstrap) embedded system debug/bootstrap environment from Red Hat distributed to you pursuant to the eCos license terms (http://ecos.sourceware.org/license- overview.html) and GNU General Public License (GPL) terms (http://www.gnu.org/copyleft/gpl.html). Source code is available upon request.

End User License Agreement

54

Image 54
Contents SmartNode 4630 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Cabling SmartNode 4630 factory configuration List of Figures List of Tables About this guide AudienceStructure Precautions Impaired functioningSafety when working with electricity General observationsTypographical conventions used in this document General conventionsChapter contents General informationSmartNode 4630 overview SmartNodeSmartNode 4630 rear panel SN4638100-240 VAC Power SmartNode 4630 front panelBRI B1/B2 Applications overview Introduction Application-Edge intelligence of enterprise communicationApplication-Multi-service Isdn Internet telephony IAD How it worksSmartNode installation Site log Planning the installationNetwork Diagram Network informationInstalling the gateway router Connecting the 10/100Base-T Ethernet LAN and WAN cables Connecting the power supply Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCLogin Configuring the desired IP addressFactory-default IP settings Changing the WAN IP addressConnecting the SmartNode to the network LANLoading the configuration optional Additional information Contacting Patton for assistance Warranty coverage Contact informationPatton support headquarters in the USA Out-of-warranty service RMA numbersAppendix a Compliance information Radio and TV Interference SafetyCompliance Pstn RegulatoryCE Declaration of Conformity Authorized European RepresentativeIsdn compliance Appendix B Specifications Voice processing signalling dependent Voice connectivityData connectivity Voice signalling Fax and modem supportVoice routing-session router System IP servicesManagement PhysicalAppendix C Cabling Connecting a serial terminal ConsoleTypical Ethernet straight-through cable diagram EthernetIsdn BRI Appendix D Port pin-outs Console port Isdn BRI 0/0 NT/Net or TE/User portIsdn BRI 0/1 . /3 TE/Usr or NT/Net Appendix E SmartNode 4630 factory configuration Introduction Appendix F End user license agreement End User License Agreement Termination Other licenses