Patton electronic 4630 user manual Typical Ethernet straight-through cable diagram

Page 45

SmartNode 4630 User Manual

C • Cabling

 

 

Ethernet

Ethernet devices (10Base-T/100Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All Ethernet ports on the SN4630 are Auto-MDX use any straight or crossover cable to connect to hubs, switches, PCs or other devices.

The interconnecting cables shall be acceptable for external use

and shall be rated for the proper application with respect to volt-

age, current, anticipated temperature, flammability, and

CAUTION mechanical serviceability.

When this device is used in North America, it shall be connected to a Network Termination Device and not connected directly to an outside POTS line.

CAUTION

 

Hub

 

Straight-through cable

RJ-45, male

RJ-45, male

1

1

2

2

3

3

6

6

 

Note: Other pins are not used.

Figure 10. Typical Ethernet straight-through cable diagram

Ethernet

45

Page 44 Page 46
Image 45
Page 44 Page 46
Contents
SmartNode 4630 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Cabling SmartNode 4630 factory configuration List of Figures List of Tables About this guide AudienceStructure Impaired functioning PrecautionsGeneral observations Safety when working with electricityGeneral conventions Typographical conventions used in this documentGeneral information Chapter contentsSmartNode SmartNode 4630 overviewSN4638 SmartNode 4630 rear panel100-240 VAC SmartNode 4630 front panel PowerBRI B1/B2 Applications overview Application-Edge intelligence of enterprise communication IntroductionHow it works Application-Multi-service Isdn Internet telephony IADSmartNode installation Network Diagram Planning the installationSite log Network informationInstalling the gateway router Connecting the 10/100Base-T Ethernet LAN and WAN cables Connecting the power supply Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCFactory-default IP settings Configuring the desired IP addressLogin Changing the WAN IP addressLAN Connecting the SmartNode to the networkLoading the configuration optional Additional information Contacting Patton for assistance Warranty coverage Contact informationPatton support headquarters in the USA RMA numbers Out-of-warranty serviceAppendix a Compliance information Compliance SafetyRadio and TV Interference Pstn RegulatoryCE Declaration of Conformity Authorized European RepresentativeIsdn compliance Appendix B Specifications Voice processing signalling dependent Voice connectivityData connectivity Voice signalling Fax and modem supportVoice routing-session router Management IP servicesSystem PhysicalAppendix C Cabling Console Connecting a serial terminalEthernet Typical Ethernet straight-through cable diagramIsdn BRI Appendix D Port pin-outs Isdn BRI 0/0 NT/Net or TE/User port Console portIsdn BRI 0/1 . /3 TE/Usr or NT/Net Appendix E SmartNode 4630 factory configuration Introduction Appendix F End user license agreement End User License Agreement Other licenses Termination
Related manuals
Manual 54 pages 39.68 Kb