TP-Link TL-WN727N manual Appendix B Glossary, 150Mbps Wireless N USB Adapter

Page 47
Appendix B: Glossary

TL-WN727N

150Mbps Wireless N USB Adapter

Appendix B: Glossary

802.11b - The 802.11b standard specifies a wireless product networking at 11 Mbps using direct-sequence spread-spectrum (DSSS) technology and operating in the unlicensed radio spectrum at 2.4GHz, and WEP encryption for security. 802.11b networks are also referred to as Wi-Fi networks.

802.11g - specification for wireless networking at 54 Mbps using direct-sequence spread-spectrum (DSSS) technology, using OFDM modulation and operating in the unlicensed radio spectrum at 2.4GHz, and backward compatibility with IEEE 802.11b devices, and WEP encryption for security.

802.11n - 802.11n builds upon previous 802.11 standards by adding MIMO (multiple-input multiple-output). MIMO uses multiple transmitter and receiver antennas to allow for increased data throughput via spatial multiplexing and increased range by exploiting the spatial diversity, perhaps through coding schemes like Alamouti coding. The Enhanced Wireless Consortium (EWC) was formed to help accelerate the IEEE 802.11n development process and promote a technology specification for interoperability of next-generation wireless local area networking (WLAN) products.

Ad hoc Network - An ad hoc network is a group of computers, each with a Wireless Adapter, connected as an independent 802.11 wireless LAN. Ad hoc wireless computers operate on a peer-to-peer basis, communicating directly with each other without the use of an access point. Ad hoc mode is also referred to as an Independent Basic Service Set (IBSS) or as peer-to-peer mode, and is useful at a departmental scale or SOHO operation.

DSSS - (Direct-Sequence Spread Spectrum) - DSSS generates a redundant bit pattern for all data transmitted. This bit pattern is called a chip (or chipping code). Even if one or more bits in the chip are damaged during transmission, statistical techniques embedded in the receiver can recover the original data without the need of retransmission. To an unintended receiver, DSSS appears as low power wideband noise and is rejected (ignored) by most narrowband receivers. However, to an intended receiver (i.e. another wireless LAN endpoint), the DSSS signal is recognized as the only valid signal, and interference is inherently rejected (ignored).

FHSS - (Frequency Hopping Spread Spectrum) - FHSS continuously changes (hops) the carrier frequency of a conventional carrier several times per second according to a pseudo-random set of channels. Because a fixed frequency is not used, and only the transmitter and receiver know the hop patterns, interception of FHSS is extremely difficult.

Infrastructure Network - An infrastructure network is a group of computers or other devices, each with a Wireless Adapter, connected as an 802.11 wireless LAN. In infrastructure mode, the wireless devices communicate with each other and to a wired network by first going through an access point. An infrastructure wireless network connected to a wired network is referred to as a Basic Service Set (BSS). A set of two or more BSS in a single network is referred to as an Extended Service Set (ESS). Infrastructure mode is useful at a corporation scale, or when it is necessary to connect the wired and wireless networks.

40

Image 47
Contents Rev 3.2.0 TL-WN727N 150Mbps Wireless N USB AdapterCOPYRIGHT & TRADEMARKS FCC RF Radiation Exposure Statement FCC STATEMENTKorea Warning Statements CE Mark WarningCanadian Compliance Statement Industry Canada StatementSafety Information Shennan Rd, Nanshan, Shenzhen, China DECLARATION OF CONFORMITYProduct Description 150Mbps Wireless N USB Adapter The product carries the CE MarkHardware Overview CONTENTSTo connect using WPS To connect using Windows built-in wireless utility Note Package Contents150Mbps Wireless N USB Adapter TL-WN727N1.1 Introduction 1.2 FeaturesChapter 1 Product Overview  Note 1.3 Hardware OverviewStatus Working Status2.2 Software Installation Chapter 2 Installation2.1 Hardware Installation TL-WN727N 5. Click Install to continue the setup 6. The utility and drivers will install. This may take 1~2 minutes TL-WN727N To connect using WPS Chapter 3 Connect to a Wireless Network3.1 To connect using TWCU To connect using TWCU TP-LINK Wireless Configuration Utility1 Wireless network of WPA/WPA2-Personal 2 Wireless network of WPA/WPA2-Enterprise 4. Please wait a few minutes for the connection process 3.2.1 PBC Push Button Configuration method 3.2 To connect using WPSTL-WN727N 3.2.2.1. Enter the PIN from your AP device 3.2.2 PIN method3.2.2.2. Enter a PIN into your AP device 2. The adapter will be connecting to the target network3.3.1 In Windows 3.3 To connect using Windows built-in wireless utility3. You have now successfully connected to the network 3.3.2 In Windows Vista 4. You have now successfully connected to the network 3.3.3 In Windows XP 2. Right-click on the wireless computer icon in your system tray lower-right corner. Select View Available Wireless Networks 3.3.4 In Windows 2. If the network is unencrypted, you will directly connect to it  Note 4.1 Profile Chapter 4 ManagementThe following items can be found on the screen 4.1.2 Modify a profile 4.1.3 Delete a profile 4.2 Advanced4.3 About Chapter 5 AP Mode  SoftAP mode Select to enable or disable the function 6.1 In Windows XP/Vista/7 Chapter 6 Uninstall Software6.1.2 Uninstall the driver software from your PC 6.2.1 Uninstall the utility software from your PC 6.2 In Windows4. Click Finish when the figure below appears 6.2.2 Uninstall the driver software from your PCTL-WN727N 150Mbps Wireless N USB AdapterTL-WN727N Environmental and Physical Appendix A SpecificationsNormal Appendix B Glossary  Spread Spectrum - Spread Spectrum technology is a wideband radio frequency technique developed by the military for use in reliable, secure, mission-critical communications systems. It is designed to trade off bandwidth efficiency for reliability, integrity, and security. In other words, more bandwidth is consumed than in the case of narrowband transmission, but the trade off produces a signal that is, in effect, louder and thus easier to detect, provided that the receiver knows the parameters of the spread-spectrum signal being broadcast. If a receiver is not tuned to the right frequency, a spread-spectrum signal looks like background noise. There are two main alternatives, Direct Sequence Spread Spectrum DSSS and Frequency Hopping Spread Spectrum FHSS