TP-Link TL-SG1204D/TL-SG1016 manual Cccccccccc Lightning Protection, Cabling Reasonably

Page 15

Gigabit Unmanaged Switch

CCCCCCCCCC Lightning Protection

3333 Cabling Reasonably

In the actual network environment, you may need cable outdoors and indoors, and the requirements for cabling outdoors and indoors are different. A reasonable cabling system can decrease the damage of induced lightning to devices.

Note: It's not recommended using Ethernet cables outdoors. When cabling outdoors, please use a signal lightning arrester.

Requirements for Cabling Outdoors

Aerial cabling without safeguard is not allowed.

It’s not allowed cabling down the building to connect network devices in different floors.

Outdoor cables should be buried and paved to the indoor through basement. A piece of steel wire should be paved underground along the pipe and connected to the lightning protection terminal of the building for shielding. Before connecting the cable to the device, install a signal lightning arrester on the corresponding port.

When an aerial cable is set up, the cable should be through a metal pipe (15m long at least\ before coming into the building. The two ends of this metal pipe should be grounded. Before connecting the cable to the device, install a signal lightning arrester on the corresponding port.

It’s not necessary to pave STP cables through pipes. The shielded layer of STP cable should be well grounded. Before connecting the cable to the device, install a signal lightning arrester on the corresponding port.

Lightning Protection 10

Image 15
Contents Installation Guide Page CE Mark Warning Copyright & Trademarks FCC StatementRelated Document About this Installation Guide AudienceConventions Contents Features Cccccccccc IntroductionProduct Overview Front Panel AppearanceLEDs Rear PanelPower Socket CCCCCCCCCCInstallation Package ContentsSafety Precautions Site Requirements Temperature/HumidityLightening Protection Installation ToolsProduct Installation Desktop InstallationRack Installation Fffffffffff Rack Installation Cccccccccc Lightning Protection Cabling ReasonablyRequirements for Cabling Outdoors Requirements for Cabling Indoors Connect to Ground Connecting to the Grounding BarEquipotential Bonding Connecting to the Ground via the Power SupplyUse Lightning Arrester Lightning Protection Ethernet Port Verify InstallationPower On CCCCCCCCCCConnectionInitialization Qqqq The Power LED is not lit Appendix a TroubleshootingFCC, CE Appendix B SpecificationsAppendix C Technical Support Gigabit Unmanaged Switch Page F106503774\ Rev