TP-Link TL-SL3226P How to connect Out-of-Band, Interface and operating way of TELNET/Out Of-Band

TL-SL3226P 24+2G Gigabit Managed Switch User's Guide

4.3How to connect Out-of-Band

Out-of-Band Management needs a terminal or a HyperTerminal.

First, connect the Switch's console port with the PC's console port by the console cord. Then, run HyperTerminal. Refer to the following figure to configure the HyperTerminal.

Figure 4-1 Console configuration

The speed of the console port is 9600bps. The data bit is 8 bit. There is no Parity Test and flow control. The Stop bit is 1.

If there is no HyperTerminal in the system, you can setup the HyperTerminal software from the system setup disk or download from the website such as

TL-SL3226P 24+2G Gigabit Managed Switch User's Guide

HyperTerminal Private Edition. The configuration way is similar with that on

Windows.

4.4 The interface and operating way of TELNET/Out-

of-Band

No matter through TELNET or Out-of-Band Management, the users have two rights:

!Admin: the control right to manage the Switch

!Guest: the read right for part of objects Admin visits.

Caution

Since Guest account has the read right only for some pages, there will be a prompt to remind the user no right for reversion when the Guest account want to configure the active the Switch. When the account wants to enter SNMP menu, Security menu, IEEE802.1X protocol menu, file transmission menu and reset menu of the system configuration menu, the account will be reminded no right to enter.

Because the basic content of TELNET and Out-of-band Management through the Console port is as same as each other, we introduce them together.

After you use the correct user's name and password (the default user's name and password are supervisor), you will log on the interface of TELNET/Out- of-Band Management.