Polycom DOC2559C First-time Power-up, For more information about specific card connections, see

Polycom RMX 4000 Hardware Guide

For more information about specific card connections, see:

•"RTM-IP 4000” on page 1-36

•"RTM ISDN” on page 1-38

•"RTM LAN” on page 1-37

First-time Power-up

1For first entry installation, you must insert the USB key containing the modified IP addresses in USB port on the RMX’s back panel.

For more information about modifying the lan.cfg file on the USB key, and using the USB key, see the RMX 2000/4000 Getting Started Guide, "Procedure 1: First-timePower-up”on page 2-14

2AC System - Turn ON the power by pressing on the power switch located on the rear panel of the RMX 4000.

DC System - Turn ON the Main that supplies power to the RMX and then turn ON the circuit breaker on the each of DC power rail modules.

The parameters in the lan.cfg file are uploaded from the USB key to the RMX’s memory and applied during the power-up sequence. System power-up sequence may take up to five minutes.

During the First-time Power-up the red ERR LED on the RMX’s front panel remains ON until both the Management and IP Network Services have been defined.

When the RMX's configuration is completed (including the Management and IP Network Services), and if there are no System Errors, the green RDY LED on the CNTL module (on the RMX’s front panel) turns ON.

3Remove the USB key.

1-21