Polycom 725-78600-002A2 manual Electrical and General Safety Guidelines

Page 11

Electrical and General Safety Guidelines

Polycom Digital Signage Server Hardware Setup

 

 

CAUTION

To avoid electrical shock, check the power cords as follows.

This product is to be installed in Restricted Access Location only.

Use the exact type of power cords required.

Use power cord(s) that came with safety certifications.

Power cord(s) must comply with AC voltage requirements in your region.

The power cord plug cap must have an electrical current rating that is at least 125% of the electrical current rating of this product.

The power cord plug cap that plugs into the AC receptacle on the power supply must be an IEC 320, sheet C13, type female connector.

Plug the power cord(s) into a socket that is properly grounded before turning on the power.

CAUTION

Required operating conditions for the appliance are -

Temperature: 10 to 35 degrees C.

Humidity, non-condensing: 8 to 90%.

CAUTION

Risk of explosion if the battery is installed upside down or is replaced by an incorrect type.

Dispose of used batteries according to the instructions.

Polycom, Inc.

7

Image 11
Contents August 2010 3725-78600-002A2 USA Contents Regulatory Notices Polycom Digital Signage Server Polycom Digital Signage SolutionAbout Polycom Digital Signage Polycom Digital Signage PlayerPolycom Digital Signage Agent Architecture OverviewPolycom Digital Signage Remote Manager Polycom Digital Signage Web ControllerCustomer Support Polycom Global Services TelephonePolycom, Inc Hardware Installation Procedures Polycom Digital Signage Server Hardware SetupEnvironmental Warning Safety Notice and WarningsElectrical and General Safety Guidelines RatingsElectrical and General Safety Guidelines Disposing of Battery Backup Units If Applicable Electrical and General Safety Guidelines Before you begin Unpacking the ApplianceSite Preparation 4-post rack assembly consists2-post rack assembly consists Setup location, rack and appliance precautionsPost Rack Installation Rack InstallationStep Three cage nuts front Small fixed M5 x 12 flat head screws* two front and rear Rear Panel Connections Front Panel Operation Polycom Digital Signage Server Setup Polycom Digital Signage Server Software SetupInstallation Installing Remote ManagerPre-Installation Procedures on Windows Vista and Windows Polycom Digital Signage Server Software Setup Polycom, Inc Starting the Remote Manager Polycom, Inc Starting the Remote Manager Polycom, Inc Regulatory Notices USA Regulatory Notices Part 15 FCC Rules Regulatory NoticesPlugs Acts as Disconnect Device