TP-Link TD-8817 manual USB Configuration, USB Drive installation procedures

Page 15

TD-8817

ADSL2/2+ Ethernet/USB Router User Guide

If the result displayed is similar to the screen shown below, it means that your PC has not connected to the Router.

Figure 3-6

You can check it follow the steps below:

1)Is the connection between your PC and the Router correct?

The LEDs of LAN port which you link to the device and the LEDs on your PC's adapter should be lit.

2)Is the TCP/IP configuration for your PC correct?

If the Router's IP address is 192.168.1.1, your PC's IP address must be within the range of 192.168.1.2 ~ 192.168.1.254.

3.2USB Configuration

If you use the USB interface, First, you must install the USB’s driver to the computer. You can obtain the drivers from the provided CD, or download from our website. (http://www.tp-link.com)

USB Drive installation procedures

Step 1: Please connect your PC to the Router through the USB port at first, then open the relative operating system folder in the CD, and double click Setup.exe to install the USB driver.

Step 2: Soon, Figure 3-7 will display after a moment. Click Next to continue.

9

Image 15

Contents TD-8817 ADSL2/2+ Ethernet/USB Router Copyright & Trademarks FCC Statement Package contents Introduction Hardware InstallationQuick Installation Guide Chapter Software ConfigurationAppendix a Specification Main Features Product OverviewTD-8817 Conventions Back Panel Front PanelHardware installation procedures Installation EnvironmentADSL2/2+ Ethernet/USB Router User Guide Configure PC Quick Installation GuideADSL2/2+ Ethernet/USB Router User Guide Configure the IP address as -4 shows. After that, click OK Is the connection between your PC and the Router correct? USB ConfigurationUSB Drive installation procedures Is the TCP/IP configuration for your PC correct?ADSL2/2+ Ethernet/USB Router User Guide Login ADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide Click Next to finish the Quick Start Status Software ConfigurationQuick Start Interface SetupInternet Dynamic IP Address PPPoA/PPPoE Static IP AddressBridge Mode 2 LAN ADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide Advanced Setup FirewallRouting 3 NAT Virtual Server DMZOther operation for the entries are as follow To add a virtual server entryADSL2/2+ Ethernet/USB Router User Guide To add a mapping rule 4 QoSADSL2/2+ Ethernet/USB Router User Guide Vlan Define Vlan Group Assign Vlan Pvid for each InterfaceAdsl 1 ACL Access ManagementIP Filter FilterADSL2/2+ Ethernet/USB Router User Guide To add an IP Address filtering entry ADSL2/2+ Ethernet/USB Router User Guide To add a MAC Address filtering entry MAC FilterADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide Other operation for the entries as shown in Figure To add a URL filter entryUPnP SnmpCwmp DdnsAdministration MaintenanceNTP Server automatically Time ZoneFirmware PC’s ClockManually To back up the Router’s current settings System Restart To restore the Router’s settingsHelp DiagnosticADSL2/2+ Ethernet/USB Router User Guide Physical and Environment General