TP-Link TD-8817 manual Bridge Mode

Page 26

TD-8817

ADSL2/2+ Ethernet/USB Router User Guide

Figure 4-7

¾Username: Enter your username for your PPPoE/PPPoA connection.

¾Password: Enter your password for your PPPoE/PPPoA connection.

¾Encapsulation: For both PPPoE/PPPoA connection, you need to specify the type of Multiplexing, either LLC or VC Mux.

¾Bridge Interface: Activate the option, the Router can also work in Bridge mode.

¾Connection: For PPPoE/PPPoA connection, you can select Always on or Connect on-Demandor Connect Manually. Connect on demand is dependent on the traffic. If there is no traffic (or Idle) for a pre-specified period of time), the connection will tear down automatically. And once there is traffic send or receive, the connection will be automatically on.

¾Static/Dynamic IP Address: For PPPoE/PPPoA connection, you need to specify the public IP address for this ADSL Router. The IP address can be either dynamically (via DHCP) or given IP address provided by your ISP. For Static IP, you need to specify the IP address, Subnet Mask and Gateway IP address.

¾Default Route: You should select Yes to configure the PVC as the default gateway to internet from this device.

4.Bridge Mode

20

Image 26

Contents TD-8817 ADSL2/2+ Ethernet/USB Router Copyright & Trademarks FCC Statement Package contents Chapter Software Configuration Hardware InstallationQuick Installation Guide IntroductionAppendix a Specification TD-8817 Main FeaturesProduct Overview Conventions Front Panel Back PanelInstallation Environment Hardware installation proceduresADSL2/2+ Ethernet/USB Router User Guide Quick Installation Guide Configure PCADSL2/2+ Ethernet/USB Router User Guide Configure the IP address as -4 shows. After that, click OK Is the TCP/IP configuration for your PC correct? USB ConfigurationUSB Drive installation procedures Is the connection between your PC and the Router correct?ADSL2/2+ Ethernet/USB Router User Guide Login ADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide Click Next to finish the Quick Start Software Configuration StatusInterface Setup Quick StartInternet Dynamic IP Address Static IP Address PPPoA/PPPoEBridge Mode 2 LAN ADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide Routing Advanced SetupFirewall 3 NAT DMZ Virtual ServerTo add a virtual server entry Other operation for the entries are as followADSL2/2+ Ethernet/USB Router User Guide 4 QoS To add a mapping ruleADSL2/2+ Ethernet/USB Router User Guide Vlan Assign Vlan Pvid for each Interface Define Vlan GroupAdsl Access Management 1 ACLFilter IP FilterADSL2/2+ Ethernet/USB Router User Guide To add an IP Address filtering entry ADSL2/2+ Ethernet/USB Router User Guide MAC Filter To add a MAC Address filtering entryADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide To add a URL filter entry Other operation for the entries as shown in FigureSnmp UPnPDdns CwmpMaintenance AdministrationTime Zone NTP Server automaticallyManually FirmwarePC’s Clock To back up the Router’s current settings To restore the Router’s settings System RestartDiagnostic HelpADSL2/2+ Ethernet/USB Router User Guide General Physical and Environment