TP-Link TD-8817 manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Image 3
Contents TD-8817 ADSL2/2+ Ethernet/USB Router Copyright & Trademarks FCC Statement Package contents Introduction Hardware InstallationQuick Installation Guide Chapter Software ConfigurationAppendix a Specification Main Features Product OverviewTD-8817 Conventions Back Panel Front PanelHardware installation procedures Installation EnvironmentADSL2/2+ Ethernet/USB Router User Guide Configure PC Quick Installation GuideADSL2/2+ Ethernet/USB Router User Guide Configure the IP address as -4 shows. After that, click OK Is the connection between your PC and the Router correct? USB ConfigurationUSB Drive installation procedures Is the TCP/IP configuration for your PC correct?ADSL2/2+ Ethernet/USB Router User Guide Login ADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide Click Next to finish the Quick Start Status Software ConfigurationQuick Start Interface SetupInternet Dynamic IP Address PPPoA/PPPoE Static IP AddressBridge Mode 2 LAN ADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide Advanced Setup FirewallRouting 3 NAT Virtual Server DMZOther operation for the entries are as follow To add a virtual server entryADSL2/2+ Ethernet/USB Router User Guide To add a mapping rule 4 QoSADSL2/2+ Ethernet/USB Router User Guide Vlan Define Vlan Group Assign Vlan Pvid for each InterfaceAdsl 1 ACL Access ManagementIP Filter FilterADSL2/2+ Ethernet/USB Router User Guide To add an IP Address filtering entry ADSL2/2+ Ethernet/USB Router User Guide To add a MAC Address filtering entry MAC FilterADSL2/2+ Ethernet/USB Router User Guide ADSL2/2+ Ethernet/USB Router User Guide Other operation for the entries as shown in Figure To add a URL filter entryUPnP SnmpCwmp DdnsAdministration MaintenanceNTP Server automatically Time ZoneFirmware PC’s ClockManually To back up the Router’s current settings System Restart To restore the Router’s settingsHelp DiagnosticADSL2/2+ Ethernet/USB Router User Guide Physical and Environment General