Schneider Electric 170 LNT 710 00 manual Connecting to the Network, Network Connector, 3 4

DeviceNet Communication Adapter

1.4Connecting to the Network

1.4.1Network Connector

The adapter has one 5–pin male connector for connection to the network. Its pin–to–pin spacing is 5.00 mm. A suggested mating connector is: Schneider Automation part 170 XTS 060 00.

Figure 3 Network Connector

Pin	Connection	Wire Color			Top View
1	V–	Black
2	CAN_L	Blue
3	Shield	– –
4	CAN_H
		White	1 2 3 4 5
5	V+	Red		Front Panel

1.4.2Network Terminator Jumper

The adapter has a jumper to provide terminating impedance to the network cable. It is shipped with the jumper in the non–terminated position (pins 3 and 4). If the adapter is being installed as the last node on the network cable, move the jumper to pins 1 and 2 and mark a “X” in the box provided on the adapter’s bottom panel.

Figure 4 Network Terminator Jumper

Bottom Panel View Rear View

Pin Termination

1/2	IN
		TERMINATED	X
3/4	OUT
The adapter is		If the adapter is the last node on the
shipped with		network cable, move the Jumper to
the Jumper on		pins 1/2, and mark an ’X’ in the
pins 3/4.		TERMINATED box on the Bottom Panel.

OUT

IN

Circuit Board

6