ZyXEL Communications omni.net LCD series Click Have Disk… and then follow the instructions below

Page 29

omni.net LCD series Quick Start Guide

Step 3. Click “Have Disk…” and then follow the instructions below.

Click “Have

Disk…”.

Make sure this BONUS CD is in

your CD-ROM drive.

Click Browse

to find the

location of the

updated Inf

file.

3-3

Image 29

Contents ZyXEL Page Table of Contents Page Introduction Front Panel Description Front Panel LEDs Back Panel Connections for omni.net LCD+M/LCD Back Panel Connections for omni.net LCD Plus Power Back Panel Switch and Connectors DescriptionRJ-45 Cable Page Plus USB-TA Install Drivers for WindowsFloppy disk drives option button Omni.net LCD series Quick Start Guide Omni.net LCD series Quick Start Guide Install your TA via a USB Interface This screen asks you where the driver located Click Next To continue With this Installation This is the end of the installation wizard Install your TA via a Serial Port RS-232 Interface This screen asks if you want Windows to detect your modem Insert the installation disk into your CD-ROM Drive Select the manufacturer and model of your TA or modem These are the files in the INF folderCOM2 refers to the port connected to your terminal adapter This screen shows you what modems are installed LCD+M/LCD Before installationInstall INF File Click Have Disk… and then follow the instructions below Click OK Next Please wait… Click Finish to complete INF files installationClick Close to exit the INF files installation Page Install ZyXEL Isdn Configuration Manager for Windows Install ZyXEL Isdn Configuration Manager for WindowsInformation about ZyXEL Isdn Configuration Manager ZylCM Determine the general location of your TA Start copying files by clicking Next Click OK Page Highlight Protocol and then click on Add… Install TCP/IPHighlight Microsoft, TCP/IP and then click OK Configure TCP/IPPPP Setup by ZyXEL Isdn Configuration Manager Omni.net LCD series Quick Start Guide Use the drop-down list to select PPP and then click OK Click on configuration icon as shown belowCreate a PPP Connection Install Driver for MacOS Install Driver and PPP Setup for MacOSClick here Click on Restart to reboot your Macintosh Close and save OT/PPP Setup for MacOSSet up TCP/IP for PPP Click Setup to show this panel’s screen Set up Remote Access or PPPZyXEL Isdn Terminal Adapter Customer Support