ZyXEL Communications omni.net LCD series quick start Install your TA via a USB Interface

Page 17

Step 3.

Step 2.

Step 1.

omni.net LCD series Quick Start Guide

Install Drivers for Windows 2000

This section provides step by step procedures to install drivers needed for the omni.net USB Terminal Adapter (TA) in Windows 2000. Install your TA via a USB interface or a serial port (RS-232) interface.

1.Install your TA via a USB Interface. This is the most typical installation.

2.Install your TA via a Serial Port (RS-232) Interface. This installation requires you to restart your computer.

1.Install your TA via a USB Interface.

Connect your USB cable to your omni.net LCD PLUS and computer. Make sure your TA is on. Windows should automatically detect that you have a new device and will give you the following Wizard window.

If you see the Found New Hardware Wizard window shown below then please continue by following the instructions in Step 3. If you do not see the Found New Hardware Wizard window below then click Start, Settings, Control Panel, double click the Add New Hardware icon and follow your computers’ prompts until your TA is detected by your computer.

Follow the instructions below.

Click Next > to

start the

Hardware

Wizard.

2-5

Image 17

Contents ZyXEL Page Table of Contents Page Introduction Front Panel Description Front Panel LEDs Back Panel Connections for omni.net LCD+M/LCD Back Panel Connections for omni.net LCD Plus Power Back Panel Switch and Connectors DescriptionRJ-45 Cable Page Plus USB-TA Install Drivers for WindowsFloppy disk drives option button Omni.net LCD series Quick Start Guide Omni.net LCD series Quick Start Guide Install your TA via a USB Interface This screen asks you where the driver located Click Next To continue With this Installation This is the end of the installation wizard Install your TA via a Serial Port RS-232 Interface This screen asks if you want Windows to detect your modem Insert the installation disk into your CD-ROM Drive Select the manufacturer and model of your TA or modem These are the files in the INF folderCOM2 refers to the port connected to your terminal adapter This screen shows you what modems are installed LCD+M/LCD Before installationInstall INF File Click Have Disk… and then follow the instructions below Click OK Next Please wait… Click Finish to complete INF files installationClick Close to exit the INF files installation Page Install ZyXEL Isdn Configuration Manager for Windows Install ZyXEL Isdn Configuration Manager for WindowsInformation about ZyXEL Isdn Configuration Manager ZylCM Determine the general location of your TA Start copying files by clicking Next Click OK Page Highlight Protocol and then click on Add… Install TCP/IPHighlight Microsoft, TCP/IP and then click OK Configure TCP/IPPPP Setup by ZyXEL Isdn Configuration Manager Omni.net LCD series Quick Start Guide Use the drop-down list to select PPP and then click OK Click on configuration icon as shown belowCreate a PPP Connection Install Driver for MacOS Install Driver and PPP Setup for MacOSClick here Click on Restart to reboot your Macintosh Close and save OT/PPP Setup for MacOSSet up TCP/IP for PPP Click Setup to show this panel’s screen Set up Remote Access or PPPZyXEL Isdn Terminal Adapter Customer Support