ZyXEL Communications omni.net LCD series quick start Install Driver and PPP Setup for MacOS

Page 47

omni.net LCD series Quick Start Guide

6.Install Driver and PPP Setup for

MacOS

This section provides step by step procedures to install the USB driver and set up PPP on MacOS.

Install Driver for MacOS

ZyXEL_USB_Installer, a MindVision VISE Installer, is used to install ZyXEL USB omni.net LCD Plus SUB driver on your Macintosh computer. Follow the instructions below.

Step 1. Be sure your omni.net LCD Plus is on.

Step 2. Insert the BONUS CD attached with your TA device into your CD-ROMdrive. You will see the icon as shown below.

Step 3. Plug the USB connector that is attached to your USB-TA into any one of your computer devices with USB port, (such as your monitor, keyboard, etc).

Note: If you have used the USB connector to connect your USB-TA with another USB device before you have inserted the BONUS CD into your CD-ROM drive, then your computer will show an error message.

Step 4. Double click on the ZyXEL_USB_Installer icon and then click Continue.

6-1

Image 47

Contents ZyXEL Page Table of Contents Page Introduction Front Panel Description Front Panel LEDs Back Panel Connections for omni.net LCD+M/LCD Back Panel Connections for omni.net LCD Plus Power Back Panel Switch and Connectors DescriptionRJ-45 Cable Page Plus USB-TA Install Drivers for WindowsFloppy disk drives option button Omni.net LCD series Quick Start Guide Omni.net LCD series Quick Start Guide Install your TA via a USB Interface This screen asks you where the driver located Click Next To continue With this Installation This is the end of the installation wizard Install your TA via a Serial Port RS-232 Interface This screen asks if you want Windows to detect your modem Insert the installation disk into your CD-ROM Drive Select the manufacturer and model of your TA or modem These are the files in the INF folderCOM2 refers to the port connected to your terminal adapter This screen shows you what modems are installed LCD+M/LCD Before installationInstall INF File Click Have Disk… and then follow the instructions below Click OK Next Please wait… Click Finish to complete INF files installationClick Close to exit the INF files installation Page Install ZyXEL Isdn Configuration Manager for Windows Install ZyXEL Isdn Configuration Manager for WindowsInformation about ZyXEL Isdn Configuration Manager ZylCM Determine the general location of your TA Start copying files by clicking Next Click OK Page Highlight Protocol and then click on Add… Install TCP/IPHighlight Microsoft, TCP/IP and then click OK Configure TCP/IPPPP Setup by ZyXEL Isdn Configuration Manager Omni.net LCD series Quick Start Guide Use the drop-down list to select PPP and then click OK Click on configuration icon as shown belowCreate a PPP Connection Install Driver for MacOS Install Driver and PPP Setup for MacOSClick here Click on Restart to reboot your Macintosh Close and save OT/PPP Setup for MacOSSet up TCP/IP for PPP Click Setup to show this panel’s screen Set up Remote Access or PPPZyXEL Isdn Terminal Adapter Customer Support