ZyXEL Communications omni.net LCD series quick start Click here

Page 48

omni.net LCD series Quick Start Guide

Step 5. Click on Install button. The ZyXEL USB device driver will be installed in the extension folder of the system folder.

Click here.

Step 6. Installation is almost complete. You must restart your Macintosh to activate the USB device driver. Click Continue.

Click here.

6-2

Image 48

Contents ZyXEL Page Table of Contents Page Introduction Front Panel Description Front Panel LEDs Back Panel Connections for omni.net LCD+M/LCD Back Panel Connections for omni.net LCD Plus Back Panel Switch and Connectors Description PowerRJ-45 Cable Page Install Drivers for Windows Plus USB-TAFloppy disk drives option button Omni.net LCD series Quick Start Guide Omni.net LCD series Quick Start Guide Install your TA via a USB Interface This screen asks you where the driver located Click Next To continue With this Installation This is the end of the installation wizard Install your TA via a Serial Port RS-232 Interface This screen asks if you want Windows to detect your modem Insert the installation disk into your CD-ROM Drive These are the files in the INF folder Select the manufacturer and model of your TA or modemCOM2 refers to the port connected to your terminal adapter This screen shows you what modems are installed Before installation LCD+M/LCDInstall INF File Click Have Disk… and then follow the instructions below Click OK Next Click Finish to complete INF files installation Please wait…Click Close to exit the INF files installation Page Install ZyXEL Isdn Configuration Manager for Windows Install ZyXEL Isdn Configuration Manager for WindowsInformation about ZyXEL Isdn Configuration Manager ZylCM Determine the general location of your TA Start copying files by clicking Next Click OK Page Install TCP/IP Highlight Protocol and then click on Add…Configure TCP/IP Highlight Microsoft, TCP/IP and then click OKPPP Setup by ZyXEL Isdn Configuration Manager Omni.net LCD series Quick Start Guide Click on configuration icon as shown below Use the drop-down list to select PPP and then click OKCreate a PPP Connection Install Driver and PPP Setup for MacOS Install Driver for MacOSClick here Click on Restart to reboot your Macintosh OT/PPP Setup for MacOS Close and saveSet up TCP/IP for PPP Set up Remote Access or PPP Click Setup to show this panel’s screenCustomer Support ZyXEL Isdn Terminal Adapter